Repair / Wichita Falls
Sprinkler Repair in Wichita Falls, TX
Dry patches, a spray that hits the driveway or a head that will not pop up. We start with the symptom, inspect the zone and explain the fix before work begins.
You may notice
- Brown or dry wedges in an otherwise healthy lawn
- Heads that tilt, sink or spray the sidewalk
- Mist or fog instead of a clean spray pattern
- A head that stays down or will not stop spraying
- Water reaching the fence, the street or the house
What we do
A spray head is the part everyone sees and the part that fails most often. Mowers clip them, nozzles clog and seals wear out. Replacing a head is simple. Knowing why that head failed is the real work.
Walk and run every zone. We turn on each zone and watch it work. We note the heads that misfire, the spots that stay dry and any water that is going somewhere it should not.
Match the part to the spot. A pop-up spray head, a rotor and a bubbler solve different problems. We choose by spacing, spray radius and the kind of turf or bed it serves.
Set the grade and the arc. New heads sit flush with the soil so a mower passes over them. We adjust arc and radius so water lands on the lawn and not on the pavement.
Reduce pressure problems. Fine mist is often a pressure issue. Where it makes sense, we recommend pressure-regulated heads that produce larger droplets.
Confirm head-to-head coverage. Before we leave, we run the zone again and check that the spray from one head reaches the next. You see what changed.
What this helps with
- Dry or stressed turf
- Water on sidewalks and driveways
- Uneven coverage between zones
- Misting and drift in the wind
- Heads damaged by mowers or traffic
What shapes the estimate
Most head and nozzle repairs are straightforward, and the estimate follows from a short list. How many heads are damaged, what type they are and how deep they sit all matter. A single clogged nozzle is a small job. A zone with a dozen mismatched heads is a different one, and in that case a coordinated replacement usually works out better than patching one head at a time.
Access plays a part too. Heads in open turf are quick. Heads in tight beds, along walls or inside rock edging take more care. We look at the whole zone before we quote, so you hear one clear price and not a string of small ones.
Before we arrive
You do not need to prepare much. A few notes help us diagnose faster.
- Note which zones look dry and when you first saw it.
- Mark any heads you know are broken with a flag or stake.
- Let us know if you have changed the schedule recently.
- Keep pets and toys off the lawn during the visit.
Wind, heat and head choice
North Texas wind pulls a fine spray off target before it reaches the grass. Low-trajectory nozzles and pressure-regulated heads keep more of the water where you aim it. It is a small change that shows up in the lawn within a few weeks.
Summers here are hot and dry, and a failed head can scorch a section of turf quickly. Wichita Falls has also lived through staged drought restrictions, so wasted water matters. A tuned zone covers the lawn with less water and leaves less to argue about when the city checks in on watering days.
Questions we hear
How do I know whether I need a new head or just a new nozzle?
If the body of the head is intact and it pops up and down cleanly, a nozzle or filter screen is often enough. A cracked body, a leaking seam or a head that sticks usually means replacement. We tell you which it is.
Why are there brown stripes in my lawn?
Stripes and wedges usually point to a clogged nozzle, a wrong arc or a head that sits too low. Walking the zone while it runs shows which one.
Should I switch to rotor heads?
Rotors suit larger open turf. Spray heads suit small and irregular areas. We recommend by zone, not by habit.
Can you fix the coverage without digging up the lawn?
Often, yes. Nozzle and arc changes need no digging. Replacing a head means a small, neat hole that is backfilled.
Do you repair commercial properties too?
Yes. The method is the same, applied across more zones.
Active problem / call directly
Do not wait on a spreading problem.
Water moving where it should not, a zone that will not stop or a system that froze. Call, and we will tell you how to shut it off safely and what to do next.
A better first step
Request an estimate for sprinkler repair.
Tell us what you see. We diagnose first, explain the likely cause and give you a clear next step before work begins.
Related services